Conference Proceedings
12th International Conference of Molten Slags, Fluxes and Salts MOLTEN 2024 Proceedings
Conference Proceedings
12th International Conference of Molten Slags, Fluxes and Salts MOLTEN 2024 Proceedings
Electrical conductivity measurement of CaO-Al2O3-CaF2 slags by van der Pauw-Ohta Method
Electro slag remelting (ESR) is one of the methods used to produce high-cleanliness steel. In the ESR method, the product steel electrode is immersed in flux, and the electrode is melted by the Joule heat of the flux generated by high current. CaF2-based melts are mainly used as fluxes, but the electrical conductivity of CaF2-based melts varies widely among researchers and measurement methods. Therefore, this experiment aims to measure the electrical conductivity of CaF2-based melts based on the van der Pauw-Ohta method, which does not require the cell constant that is a fundamental error factor in electrical conductivity measurement at high temperatures. The measurement temperature was set at 1450–1600°C, and dehydrated Ar flowed through the furnace at 200 mL/min. Electrodes were fabricated by Pt-30mass per cent Rh alloy, and the electrodes were connected to an impedance analyser using a four-terminal probe. The electrodes were immersed in the melt, and the impedance and phase angle were measured by AC frequency sweep (50 Hz to 200 kHz). The electrical conductivity was then calculated by utilising the impedance’s real part values when the impedance’s imaginary component was zero. The electrical conductivity showed a positive temperature dependence. The electrical conductivity of 60(CaO⋅Al2O3)-40CaF2 melt increased with increasing temperature but was found to be roughly one-third of those of the previous studies. In the conductivity measurement of 60(CaO⋅Al2O3)-40CaF2 melt, the AC frequency with a phase angle of 0° was found to be different depending on the temperature and immersion depth. By sweeping the frequency, the impedance at the phase angle of 0° can be obtained, which enables us to measure the electrical conductivity more accurately.
Contributor(s):
K Aya, T Sumita, N Saito, K Nakashima
-
Electrical conductivity measurement of CaO-Al2O3-CaF2 slags by van der Pauw-Ohta MethodPDFThis product is exclusive to Digital library subscription
-
Electrical conductivity measurement of CaO-Al2O3-CaF2 slags by van der Pauw-Ohta MethodPDFNormal price $22.00Member price from $0.00
Fees above are GST inclusive
PD Hours
Approved activity
- Published: 2024
- Unique ID: P-04047-R4Y9P0