Conference Proceedings
Ground Movement and Control Related to Coal Mining, Wollongong
Conference Proceedings
Ground Movement and Control Related to Coal Mining, Wollongong
Evaluation of a Two Lift Thick Seam Mining Method Based on Partial Extraction of 6m High Square Pillars with Relatively Small Width
This paper presents the results of in-situ and laboratory investigations into a mining method which utilises conventional continuous mining techniques to carry out two passes in thick coal seams, resulting in the development of stable pillars with relatively small width dimensions and heights up to 6 m. Geotechnical investigations included structural mapping, brightness logging and standard laboratory testing. Virgin stress was measured using overcoring techniques. Two approaches to pillar design were used in the study. These were; pillar design based on empirical formulae and laboratory testing, and pillar disign using calibrated mathematical models. A trial panel was developed at 300 m depth to study pillar deformation and stress changes due to mining. The extent of rib deformation was studied using borescopes and extensometers._x000D_
In-situ geotechnical measurements were used to calibrate displacement discontinuity and finite element mathematical models of the coal seam._x000D_
These models were then used to predict the behaviour of a small panel of pillars which were to be developed to 6 m height. The mining method was shown to be feasible provided adequate rib support was installed._x000D_
The benefit of rib support was found to be two-fold, in that it increased confinement of the pillar in zones of low horizontal stress, while reducing horizontal stress relaxation in zones of high horizontal virgin stress. The possiblity of roof control by designing the small pillars to yield on retreat is discussed.
In-situ geotechnical measurements were used to calibrate displacement discontinuity and finite element mathematical models of the coal seam._x000D_
These models were then used to predict the behaviour of a small panel of pillars which were to be developed to 6 m height. The mining method was shown to be feasible provided adequate rib support was installed._x000D_
The benefit of rib support was found to be two-fold, in that it increased confinement of the pillar in zones of low horizontal stress, while reducing horizontal stress relaxation in zones of high horizontal virgin stress. The possiblity of roof control by designing the small pillars to yield on retreat is discussed.
Contributor(s):
G J O'Regan, P A Mikula
-
Evaluation of a Two Lift Thick Seam Mining Method Based on Partial Extraction of 6m High Square Pillars with Relatively Small WidthPDFThis product is exclusive to Digital library subscription
-
Evaluation of a Two Lift Thick Seam Mining Method Based on Partial Extraction of 6m High Square Pillars with Relatively Small WidthPDFNormal price $22.00Member price from $0.00
Fees above are GST inclusive
PD Hours
Approved activity
- Published: 1986
- Unique ID: P198603009