The great advances made in the application of solvent extraction to the recovery of copper from low grade ore sources over the past 15 to 20 years are well known. Solvent extraction is an essential step in the recovery and purification of copper from dilute sulphate leach solutions by which some one million tonnes of copper are now electrowon annually. A reagent is also available for the selective recovery of copper from chloride leach solutions and this may hold the key to the processing of complex sulphide ore concentrates. By comparison, the use of solvent extraction in the recovery and processing of zinc has as yet found little favour and is confined to only a few specific and comparatively small applications. This is despite the ready availability of a large number of low grade zinc sources and zinc-bearing wastes and residues. It is suggested that this difference is due in large part to the absence of suitable reagents having the particular features required to enable them to fit into a solvent extraction - electrowinning based process for zinc. Ideally, for the recovery of zinc from dilute sulphate solution, an extractant should operate on a proton exchange principle and be strong for zinc in the same way that o-hydroxyaryloxime reagents are strong towards copper. It should load efficiently with zinc at the pH of typical sulphate feed streams without the need for neutralisation and yet be stripped efficiently by spent zinc electrolyte. Another factor of major importance for many applications, however, is that it should be highly selective for zinc over ferric iron. These features have now been realised in a development extractant DS5846, which is a formulation of a novel class of reagent currently under investigation by Zeneca Specialties. The properties of this reagent are described with respect to selectivity, isotherms and how they compare with phosphoric and thiophosphoric acids that have been previously proposed for the extraction of zinc. For the recovery of zinc from concentrated chloride solutions a solvating or neutral donor type of extractant is required which again should ideally have high selectivity for zinc over a number of other metals, particularly iron. The new reagent Acorga ZNX50 is based on a formulation of a novel class of compound developed specifically for this purpose. It gives efficient extraction of zinc from feed solutions that are four to six molar in chloride ion but is readily stripped at 60 - 65C using either water, dilute brine, or spent zinc chloride electrolyte. The reagent is highly selective for zinc over iron and a range of other metals including cadmium, arsenic, lead and magnesium.